Technical University of Denmark
Browse
.E
bracket_TOmesh.e (50.41 MB)
.E
michellCantilever_TOmesh.e (15.05 MB)
.E
lotteTower_TOmesh.e (27.5 MB)
1/0
3 files

Efficient Inverse-designed Structural Infill for Complex Engineering Structures: Multi-scale Optimization mesh

dataset
posted on 2023-10-10, 10:44 authored by Peter Dørffler Ladegaard Jensen

Exodus II hex mesh data files of unstructured multi-scale optimization from the paper "Efficient Inverse-designed Structural Infill for Complex Engineering Structures". The mesh files have side sets for applied load case and boundary conditions. The load cases and boundary conditions are found in the paper. The data set contains the results of the three models used in the paper: the Michell cantilever, the Lotte tower, and the GE Jet Engine Bracket.

Abstract cited from DOI: https://doi.org/10.48550/arXiv.2307.09518 :
"Inverse design of high-resolution and fine-detailed 3D lightweight mechanical structures is notoriously expensive due to the need for vast computational resources and the use of very fine-scaled complex meshes. Furthermore, in designing for additive manufacturing, infill is often neglected as a component of the optimized structure. In this paper, both concerns are addressed using a de-homogenization topology optimization procedure on complex engineering structures discretized by 3D unstructured hexahedrals. Using a rectangular-hole microstructure (reminiscent to the stiffness optimal orthogonal rank-3 multi-scale) as a base material for the multi-scale optimization, a coarse-scale optimized geometry can be obtained using homogenization-based topology optimization. Due to the microstructure periodicity, this coarse-scale geometry can be up-sampled to a fine physical geometry with optimized infill, with minor loss in structural performance and at a fraction of the cost of a fine-scale solution. The upsampling on 3D unstructured grids is achieved through stream surface tracing which aligns with the optimized local orientation. The periodicity of the physical geometry can be tuned, such that the material serves as a structural component and also as an efficient infill for additive manufacturing designs. The method is demonstrated through three examples. It achieves comparable structural performance to state-of-the-art methods but stands out for its significant computational time reduction, much faster than the base-line method. By allowing multiple active layers, the mapped solution becomes more mechanically stable, leading to an increased critical buckling load factor without additional computational expense. The proposed approach achieves promising results, benchmarking against large-scale SIMP models demonstrates computational efficiency improvements of up to 250 times."


Funding

InnoTop - Interactive, Non-Linear, High-Resolution Topology Optimization

The Velux Foundations

Find out more...

History

Usage metrics

    DTU Construct

    Licence

    Exports

    RefWorks
    BibTeX
    Ref. manager
    Endnote
    DataCite
    NLM
    DC